Radio or Cruise control switch fitting

Created:16. 06. 2003
Updated: --. --. ----

This document concerns all COM 2000 units

Problem: It may sometimes be difficult or impossible to secure the radio control switch or the cruise control switch to the COM 2000 unit.

Cause: This can be caused by interference of the switch with the triangular section at the shroud bracket. (See picture)

Solution: Remove as little material as necessary so the switch can be fully pushed home.

COM2000 Left: Section of COM 2000 showing the slot for the radio switch. The area which can prevent the switch from locking in is marked red. Remove material from that part until the switch can be pushed to the point where it locks in place.

Technical information by